Paste filling machine is a kind of high intensity filling capacity of equipment, if the maintenance is not very good, not only can destroy the service life of automatic filling machine, is also likely to suddenly difficult problem in the operation process, lead to shut down, causing great inconvenience to make paste filling machine all normal smooth functioning again, must even more pay great attention to the daily operation maintenance of the machine.
Common problem: paste filling machine filling found in the process of measurement is not stable, check into the material check valve is likely to have dirt, causing sealing loose, harm filling quantity; Cylinder bottom material overflow indicates that the piston rod sealing ring is worn, must changing a sealing ring. Paste filling machine filling positions into automatic and manual type filling two kinds, when machine ratio of high to width, select manual type method, choose manual type method, as long as with the cork promote mouth breathing gradually, keep touching your mouth, if it is fully automated, be sure to put the glass bottles in inlet directly, as soon as the power switch to the fully automatic filling gradually, and instantly changing a glass bottle.
Examine the tu face whether leak into the air, the gas pressure is 0.3 ~ 0.4 MPa, adjust into the remaining oil. General situation, several liquid spray after a drop of oil leakage, and regular maintenance fluid leakage. Filling quantity adjustment: turn the filling quantity adjustment before the main shaft, observe the indicator the size of the dialog box, do filling amount, adjust the absorption rate, achieve satisfactory filling effect. Filling amount, the correct filling quantity. Oil to actual operation: open the right door, rotating RunHua oil level and add clean special lubrication oil or butter, (do not application standard to the oil, residual oil should be the full 8 minutes up and down).
If the machine is unusual, more to check whether all machine adjustment buttons to adjust in a timely manner, and check all pins, ensure properly handle these small problems. (should be in the operating process completely clean, wipe with soft non-woven and cleaning fluid to the oil, then dry with a soft non-woven fabric, according to the GMP regulation, inspection equipment and raw materials of the touch location whether accord with relative cleanliness requirements, if not, please clean out their ears and dry again, clear the way according to the machining process.
